When processing hardware accessories, safety is the first priority, so what should be paid attention to when processing hardware accessories? Here are a few things.

1. The engineer and the start-up personnel are required to maintain the correct posture, have sufficient sleep, and concentrate on the operation. They cannot chat or cooperate with each other. The start-up personnel should not operate in a state of irritability and fatigue. To ensure the safety of operators. Before entering the workplace, all personnel check whether their clothing meets the work requirements before going to work every day. Slippers and high heels are not allowed, and those with long hair must wear safety helmets.

2. Before starting the machine, check whether the moving parts are filled with lubricating oil, and then start and check whether the clutch and brake are normal. Run the equipment for 2-3 minutes. When the equipment is faulty, it must not be operated.

3. When starting the power supply, all other people must leave the working area of the equipment and start the equipment after removing the sundries on the equipment workbench.

4. When the equipment is working, it is absolutely forbidden to put your hand into the working area of the slider, and you cannot take and place the workpiece by hand. Special tools are required when picking and placing workpieces in the die. It is found that the equipment has abnormal sound and the machine fails, and the power must be turned off immediately for inspection. After the equipment is started, an engineer will transport the materials and operate the equipment. All personnel must not press the electric switch or step on the foot switch board. For their own safety, they must not put their hands in the mechanical work area and touch the moving parts of the machinery by hand.

5. When replacing the mold, the power supply must be turned off. After the punch personnel stop running, they can start to install and debug the mold. After installation and adjustment, move the flywheel by hand for trial punching for two to three times. In order to make unnecessary collision between the machine and the processed products, the upper and lower molds must be checked for symmetry and rationality, whether the screws are firm, and whether the blank holder is in the correct position.